AKYAPAK Welding Solutions – Rope Rotators
Rope Rotators are used to rotate and position pieces with planar section. Required welding edge can be created by realizing positioning according to the rotated part on an endless rope. It is possible to adjust the height of the piece placed on the machine. This provides convenience to the operator during welding.
The product comprises of housing, rope drive systems, electrical panel and remote controlled operator unit and rovides the best structural protection. Measures have been taken against the carrier with a lift rope break. Even if bobbin carrier part of the elevator rope overlaps. The operator or the machine will not damage any area.
Operators can rotate the pieces mounted on the rope clockwise or counterclockwise, precisely, well-aligned and easily. They can also be moved downward – upward to provide the desired height. Rope rotator set comprises of 2 driven units. Number of units can be increased according to the application and weight conditions.
Both of the units which constitute the rope rotator set are driven and these two unit can be operated in synchronization or independently. Thus, angular height adjustment of the work piece is enabled.
- Remote controller with 5 meter cable length
- Adjusting the handle rope the desired angle (Hydraulic)
- Except as part of rope carry lift group
- Hydraulic unit provides easy to use
- Drive system with hydromotor
- Wireless remote controller
- Special insulations for worksite conditions
OVER 120 YEARS TECHNICAL EXPERIENCE | THE NEW CHOICE IS TRILOGY MACHINERY